First of all, it is particularly important to choose a good product. You can choose from the following three directions:
I. quality: the quality of terminal machines always comes first. After all, buying terminal machines is to be put into production. The quality of terminal machines is closely related to the quality of products. As for what type of terminal machine to buy? It should be selected according to the actual needs. Of course, no matter what type of machine you buy, quality comes first.
II. After sales service: after the quality, it depends on the after-sales service. The machine will always have problems and faults. No matter how good the quality is, the terminal machine may be damaged due to improper operation and maintenance, overuse and other problems after working for a long time. It needs to be repaired. At this time, a good after-sales service is needed. Therefore, the manufacturer's after-sales service is also the most important after quality.
III. price: after paying attention to the first two issues, let's look at the price. There are many price differences between different types and series of terminal machines, and the prices of machines of different quality are also very different. This requires you to measure and compare the left and right. However, please believe that a penny for a penny will make your products expensive, while a cheap product doesn't need a reason. Buy terminal machine automatic terminal machine full automatic terminal machine full automatic terminal machine manufacturer tin dipping machine automatic tin dipping machine automatic tin dipping machine manufacturer Ruixin automation gives you satisfactory equipment.
Troubleshooting and maintenance of Dongguan Ruixin automation:
1. The foot switch is bad, replace it. 2. Check the proximity switch in case of continuous play.
3. Replace the fuse if it is blown. 4. The mechanical action is slow. Add butter 1-3 times a day to the oil holes of the sliding block (1 hole and 3 sliding surfaces) and the die (3 holes). Mechanical operating ambient temperature (- 2 ° to 50 °).
5. In case of motor failure (smoke and odor), replace the motor 180W and pay attention to the motor voltage.
6. The die is stuck and cannot slide up and down: Turn the screw at the tail of the main shaft with a wrench to make the main shaft drive the slider to slide up and down and drive the punch. Check whether the upper and lower riveting knives are bruised, scratched terminals and stuck with the upper knife.
7. Tool die replacement: Note: please put the machine in manual state when replacing the tool die.
Pay attention to whether there is obvious abnormal noise inside and outside the machine. If the operation is suspended, ask the machine maintenance personnel to determine whether it needs maintenance.
Knife selection and installation: it is operated by designated personnel. Before installing the knife, it is necessary to manually compare whether the selected blade is matched. After the comparison is correct, the knife can be installed. After installing the knife, it must be tested by hand. First, turn off the power supply of the terminal machine, press the down button, and use a special board hand to shake the master-slave wheel to maximize the stamping stroke of the terminal machine. If the hand does not move, Consider whether the pressure is too high or other problems, and check and debug to OK. Before operation, each locking screw shall be checked and confirmed to be free from looseness Loading: install the terminal to be punched, use the hexagonal wrench to adjust the feeding pressing plate so that the terminal can pass easily, visually check whether the feeding position is appropriate, if not, adjust it, use the hexagonal wrench to loosen the locking screw of the feeder, screw the adjusting rod to adjust until it reaches the best state, then lock the locking screw of the feeder and start the operation. Test the tension: after the adjustment is OK, take the waste wire rod for trial beating and conduct the tension test. The main reference values are shown in the comparison table of tension test. The specific operation methods are as follows: press the zero key of tension test to zero, clamp the terminal wire rod to be tested, and conduct the test. If the measured tension is not within the standard range, ask the machine maintenance personnel to readjust it until it reaches the standard value.
